
- Quiet - Doesn't interfere with the memory - RGB setup was pretty normal - Temperatures seem decent

Quality build. Cools really well, nice looking cooler.

Look GoodEasy InstallationGood CPU Support

Excellent!!

It worked like it should and lowered my HTPC old Intel 3770K temps down 10 to 15 degrees from stock cooler. Fan was loud at 2200 rpm but I had a Natua resister low noise extension power lead that lower the rpm to 1100 and it is now silent!


Quiet. Keeps a i7-5930K @ 3.5GHz at 40-41C with virtually no audible noise at idle. Installation is nice--there are vertical holes all the way through the cooling fins at each corner, and they provide a long hex driver that extends down through the holes to engage the mounting screws, so no access at all from the side is required to get the thing on or off even for the "square" hole pattern where you usually have to get under the cooler to get to the mounting screws. Removing and replacing the fan would be trivial even with the unit in place--remove two wire clips that engage the heat sink fins, and pull the fan out vertically.


Keeps a Threadripper 1950X (not overclocked) at approximately 30C at idle and has never exceeded 62C at load. The hardest part of the installation is figuring out how much thermal paste to apply.



It's is enough to keep a stock 1700X cool. Good enough for me.

.jpg)
extremely quiet seemed to cool i5 9400f well under load easy to install with the sticky bracket for the motherboard copper insert pre-applied thermal paste worked well

Inexpensive. Largest cooler that will fit in my case. Using this to quite down an old A10, the stock coolers tend to be a little weak.


Great price Exceptional cooling ability RGB and white is great for those who like it Well built and designed Easy to install


