BEST SELLERS

In Water / Liquid Cooling

-The RGB fans look nice -Keeps my CPU cool -The daisy-chained fan connectors are helpful when building

Quiet and easy to install.

The daisy-chain linking of the fans was nice for getting each fan connected for both power and RGB functioning. Extension cables are also included. The pump blocks RGB connector can also be linked as the beginning of the chain leading to the motherboard. The pump is extraordinarily quiet; using a dB meter up close barely registers. The fans are also very quiet until throttled up to their highest RPM, and even then it is merely a whisper. The coolant hoses are reasonably flexible without kinking and are also long enough to extend past full length GPU cards and reach the bottom of the case in a front mount configuration. Keep in mind, over time, most coolants will develop air pockets and it is best to trap that air away from the pump to insure the greatest lifespan of your AIO cooling system and minimize gurgling sounds. This is why your hoses should always be oriented at their lowest points on both the pump and the radiator. Thermal paste is pre-applied to the pump block and there should be no need to add more. Alternatively, a white variant of this model is also available.

Amazing AIO. Fans already preinstalled. Easy instructions to follow. Cools my CPU no issue

-Price -Aesthetic -Performance -It's MSI meaning its reliable

Everything is excellent. As described.

This is my first AIO cooler. I've always leaned towards high end air cooling in the past and I have to say I'm beyond impressed by what I'm seeing (and not hearing!) in this TRYX AIO. The heatsink (dual fan) I replaced with this was definitely skirting the mid-high to high end air cooling solutions. Not only does the TRYX keep my idle temps a few degrees cooler but under load with moderate gaming the temps are literally 10 degrees cooler. (i7 10700k with a mild overclock) Under extreme loads it sits around 10-15 degrees cooler but far less noisy compared to my air cooler. If I crank the fan speed up it will stay consistently ~15 degrees cooler than the air cooling. But the most impressive part of that is the silence. I'm able to maintain the level of cooling I am right now (check the included screenshot) without the need to have the TRYX fans spin up to an audible level. The pump is also silent. To the point I questioned if it was even running the first time I turned it on! Under heavy duty gaming the TRYX is still able to maintain significantly lower temps at much lower fan speeds. The silence really is golden. I really can't stress how quiet this is while still maintaining great temps. The ARGB lighting is a nice touch and added to the theme of my entire build. Keep in mind you need to either have support for it on your motherboard or a controller. There is no way to adjust the lighting without it. The install is simple. Took all of 10 minutes to get setup. Instructions are easy to follow. The screen can be mounted at different orientations, vertical and horizontal. All customizable through the software. You can also add some neat effects like rain or fog. There's ways to split the images as well and treat the display as two screens. Speaking of the software... this leads me to my one con.

Pretty damb good mached with Noctua past overclocked really good not passing 50°C gaming and 30°C Idle.

Optimal game mode keeps my ryzen 9 7950x below 80c. idle 37c. note: has 100% matching case fans. i love it so far

The aio has run well so far. Playing Star Wars Battlefront 2 my cpu would run at 86 C* on the AMD cpu cooler, which was a little high for my comfort. I installed the AIO which was fairly easy to do. Be careful when trying to remove the old cpu fan as to not rip out the cpu socket. The water cooler needs to be attached to a usb 2.0 and the AIO cooler on the motherboard. Then the wires for the fan I ended up daisy chaining with my other cpu fans and they worked at first boot up. I needed to buy a fan hub (aigoo) previously so just plugged the AIO fan into the hub and had the hub connected to cpu fan on the motherboard. Since running the AIO cooler Star Wars Battlefront 2 now the cpu runs at 66 C which is almost a 20 C drop which I was pleasantly suprised. The software isnt great but I was able to customize the display which I found super awesome. My PC theme is Dragon Ball Super Goku SSJ Blue. I was able to download a clip of Goku Powering up and was able to get the video on the water cooler display. I have been very happy with this cooler so far but it has only been 1 day. The AIO cooler does come with thermal paste as well so no need to buy new thermal paste.

I have both the nautilus 240 rs and 360 rs, both have worked amazing right out of the box with zero issues and cools great. Although i do recommend use a commander core xt (if you can buy one) it makes controlling the fan speeds and RGB a lot easier. But besides that i highly recommend because theyre not too expensive and the fans that come with, they push and pull a great amount of air. Perfect for someone looking to do a white build or to upgrade their AIO.

The LCD display looks great not a secondary monitor but a independent screen

- Price - Ease of Instal - Cooling - Promotional

The product is well designed and comes with everything you need for your build. The exterior design is also very cool and I chose this one specifically for the white exterior to suit my new build.

looks great and runs very well. very easy to install