Coolwell 2.13 Inch Flexible E-Ink Display HAT Module Black/White SPI Interface E-Paper for Raspberry Pi 2B/3B/Zero/Zero W Supports Partial Refresh for Curved Surface Display

Overview

This is a flexible E-Ink display HAT for Raspberry Pi, 2.13 inch, 212x104 resolution, with embedded controller, communicating via SPI interface, supports partial refresh.

Compared with normal e-Paper panels, this flexible panel allows bending without being damaged, and it's thinner and lighter.

Combined with the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications where curved
surface display is required, such as industrial instruments, smart wearable-devices, and so on.

Features

No backlight, keeps displaying last content for a long time even when power down
Ultra low power consumption, basically power is only required for refreshing
Compatible with Raspberry Pi 2B/3B/Zero/Zero W
Preserved solder pads for SPI interface, for connecting with other controller boards like Ardui/Nucleo, etc.
Comes with development resources and manual (examples for Raspberry Pi/Ardui/STM32)

Specifications

Operating voltage: 3.3V
Interface: 3-wire SPI, 4-wire SPI
Outline dimension: 59.2 mm x 29.2 mm x 0.3 mm
Display size: 23.71 mm x 48.55 mm
Dot pitch: 0.229 x 0.228
Resolution: 212 x 104
Display color: black, white
Grey level: 2
Full refresh time: 2s
Refresh power: 26.4 mW(typ. )
Standby power: <0.017mW
Viewing angle: >170deg

Package Content

2.13 inch e-Paper (D) x1
e-Paper Driver HAT x1
RPi screws pack (2pcs) x1
PH 2.0 20cm 8Pin x1

Development Resources

www. waveshare. com/wiki/ 2.13 inch_e-Paper_HAT_ (D)