Watercool MO-RA IV 600 Ambient Light aRGB (26640)

An aRGB LED strip for the MO-RA IV 600 radiator, attached to the lower part of the housing for an indirect lighting effect. The Watercool MO-RA IV 600 Ambient Light aRGB runs on +5 V through a 3-pin connector, and a MO-RA IV Active or Passive Control is required to use it.

Properties

• Compatible: MO-RA IV 600
• Operating voltage: +5 V
• Connector: 3-pin (5VDG, 5V)
• Needs: MO-RA IV Active or Passive Control

Indirect light under the radiator

The Ambient Light allows you to customize the MO-RA IV. Watercool fits a high-quality LED strip underneath to create an indirect glow on the surface below. Watercool says this not only looks first-class but also enhances the radiator.

The strip is supported by all common motherboard manufacturers. That means Watercool's aRGB solution can be easily integrated into any lighting concept.

Mounting

Take the feet off first. Feed the cable of the LED strip from the outside through the hole in the lower part of the housing, then lead it out at the back to the Active Control or Passive Control. Pull the protective film off the double-sided adhesive tape on the back of the strip. Stick the strip to the bottom part of the housing, as centrally as possible, and refit the feet.

Options

Watercool's technical data name the MO-RA IV 600 as the compatible radiator. The matching light for the front of the same radiator is the MO-RA IV 600 Front Logo aRGB (26641). The MO-RA IV 400 has its own Ambient Light aRGB (26440).

In the box

The scope of delivery is the strip alone.

• 1x MO-RA IV Ambient Light aRGB