DIY Cooling

• Brand: Phanteks
• Series: Glacier R220C
• Type: Combo Reservoir
• Specification: Pump Compatibility: DDC Installation Compatibility: 120/140 mm fan/radiator Seal O-Ring: DuPont VITON Reservoir - ID: 126.72 /W: 1.78 (AS049) Color: Transparent RGB LED type: Digital-RGB (addressable) LED Number: 5050, 18pcs LED Electricity Spec: 5V/ 0.7A/ 3.5W Capacity: 200ml Materials: Acrylic body, Acrylic backplate, Steel bracket Max Water Loop Temperature: 60 degree C Fill Port: 1 x G 1/4 No. of Inlet: 3 x G 1/4 No. of Outlet: 1 x G 1/4
• Model #: PH-R220C_02

• Brand: Phanteks
• Type: Radiator
• Radiator Size: 470x140x30 mm
• Radiator Material: Fins: T2 Copper Water Chamber: H62 Brass Thread Insert: H59 Brass Side Pane: 430 Stainless Fittings: Brass Fitting Insert: ABS
• Model #: PH-GEF-RAD423_BK

• Type: Tool Set
• Specification: Materials Tube Cutter: Plastic + Steel Bending Insert: Rubber Bending Guides: PP Squeeze Bottle: PE 24-Pin Jumper: PP Sandpaper: Paper Tube Cutter Compatibility 16 mm Hard Tube Bending Insert Compatibility For ID:12mm / OD:16mm Hard Tube Bending Guides Compatibility 16 mm Hard Tube Squeeze Bottle Capacity: 250 ml Sandpaper Grit: 240
• Package Contents: Tube Cutter 1x Silicone Bending Insert 1x Bending Guides (set) 1x Squeeze Bottle 1x 24-Pin Jumper 1x Sandpaper 1x Manual 1x
• Model #: PH-GEF_TLS_BK

• Type: Fan power cable
• Type: PWM 4pin fan hub splitter
• Color: Black
• Length: 16inches / 40CM
• Model #: PWMHUB10S

• Model #: 11-001-024

• Model #: ACFRE00114A

Limited time offer, ends 02/01

• Color: Black
• Model #: HDALMBK-2P

• Model #: 11-001-025

(8)

• Model #: CL-W193-CU00BL-A

• Model #: DZ-ZHT-035-A

• Model #: 11-001-356

• Color: Black
• Compatibility: Motherboard Chipsets
• Features: Anodized Black Aluminum heatsink for Computer General northbridge ,Southbridge Cooling ,also can be used for cooling graphics card, vidoe card,motherboard, power transistor, FET, IC, power amplifier, Voltage Regulator,etc. The fins increase the area of the board and thus provide for greater heat transfer. Use heatsink adhesive glue to install heatsink on the IC.Glue is not included here. Size is 28mm x 28mm x 20mm low profile , Please check the specification table and make sure that the size of the heatsink fits that of your component. Specification Product Name: Heatsink Material: Aluminium Color: Anodized Black Overall Size: 28 x 28 x 20mm/ 1.1" x 1.1" x 0.8" (L*W*H) Weight: 30g Package Content: 2pcs x Heatsink
• Dimensions: 28 x 28 x 20mm
• Model #: 11-001-327

• Color: Silver
• Compatibility: VGA Chipsets
• Features: Aluminum heatsink are generally used in the heat treatment and the fins increase the area of the board and thus provide for greater heat transfer. GPU graphics card Cooling Heatsink Kit is a fan-less cooling solution to any GPU, graphics card, video card. And,Widely use for computer PC chipset, power IC, power electric device, LED light devices, etc. Use heatsink adhesive glue to install heatsink .(Glue is not included) Please check the specification table and make sure that the size of the heatsink fits that of your component. Specification Product Name :GPU Video Card Heatsink; Material : Aluminium Color : Silver Tone Package Content : 15 pieces - 8.8mmx8.8mmx5mm Heatsink 10 pieces - 14mmx14mmx6mm Heatsink 8 pieces - 20mmx14mmx6mm Heatsink
• Dimensions: 15 pieces - 8.8mmx8.8mmx5mm Hea...
• Model #: 11-001-128

• Brand: EN-Labs
• Model #: 36WPCICON5D

(7)

• Part Number: CL-W332-CU00SW-A
• Type: CPU Block
• Block Compatibility: Intel LGA 1700 / 1200 / 1156 / 1155 / 1151 / 1150 AMD AM5 / AM4 / AM3+ / AM3 / AM2+ / AM2 / FM2 / FM1
• Block Dim.: 92.00 x 92.50 x 64.00 mm
• Model #: CL-W332-CU00SW-A

• Model #: 11-001-061

• Color: Black
• Compatibility: Motherboard Chipsets
• Features: Anodized Black Aluminum fin heatsink cooling , generally used in heat treatment and the cooling IC and electronic component, for example: RAM, CPU Memory , GPU, Graphics Card, Vidoe Card,also can be used for cooling of , northbridge ,Southbridge ,motherboard, power transistor, FET, IC, power amplifier, Voltage Regulator,1W LED etc. The fins increase the area of the board and thus provide for greater heat transfer. Use heatsink adhesive glue to install heatsink on the IC.Glue is not included here. Size is 28mm x 28mm x 11mm low profile , Please check the specification table and make sure that the size of the heatsink fits that of your component. Specification Product Name: Heatsink Material: Aluminium Color: Anodized Black Overall Size: 28 x 28 x 11mm/1.10" x 1.10"x 0.43"(L*W*H) Weight: 5...
• Model #: 11-001-329

• Model #: 11-001-359

• Model #: 11-001-236

• Model #: 11-001-235

• Model #: NM-i4189

• Model #: 11-001-015

• Model #: 11-001-100

• Compatibility: Motherboard Chipsets
• Features: These heatsinks have a layer of thermal adhesive that allow for easy installation on to your board. These heat sinks have profiles which are short enough to fit within standard Raspberry Pi cases. Pure copper heatsink thermal conductivity up to 401w / mk,good idear for processor,CPU and GPU cooling,Tested to fit the Raspberry Pi CPU / SoC,reduce the risk of hardware failure due to overheating. These heat sinks include adhesive thermal tape for efficient thermal transfer to the heat sink providing additional cooling to the IC. Also, it is easy to remove with a razor blade, so you can remove the heatsink without damaging the chips. These heat sinks can be used with other devices such as the Beaglebone to cool processor, regulators, etc. Installation Instructions: -Make sure the chip modules are free from dirt and gre...
• Model #: 11-001-098

• Color: silver
• Compatibility: CPU
• Features: These heatsinks have a layer of thermal adhesive that allow for easy installation on to your board. These heat sinks have profiles which are short enough to fit within standard Raspberry Pi cases. Tested to fit the Raspberry Pi CPU / SoC; Reduce the risk of hardware failure due to overheating. These pure aluminum heat sinks include adhesive thermal tape for efficient thermal transfer to the heat sink providing additional cooling to the IC. Also, it is easy to remove with a razor blade, so you can remove the heatsink without damaging the chips. These heat sinks can be used with other devices such as the Beaglebone to cool processor, regulators, etc. Installation Instructions: -Make sure the chip modules are free from dirt and grease. -Peel the protective liner off on the base of the heatsink. -Apply the heatsi...
• Model #: 11-001-255(10)

• Model #: 11-001-255(2)

• Compatibility: CPU
• Features: This Copper Shims thermal conductivity up to 401w / mk, and ordinary copper thermal conductivity is only 20-30w / mk CPU and GPU graphics card in the inside part of the laptop using a thermal plastic thermal conductivity, thermal plastic at high temperature for a long time easy to aging, and ultimately lost, leading to overheating of the CPU or GPU, the Laptop will not start after overheating. With this copper pad to greatly lower gpu temperatures, can be used for graphics, northbridge, CPU chips. It can be used as heatsink solution for Xbox ,PS4 and all laptop and computer such as HP,Dell,Acer,Thinkpad etc. Package included: 10 pcs Thermal Conductive Copper Shims 20mm x 20mm x 0.5mm
• Dimensions: 20mm x 20mm x 0.5mm
• Model #: 11-001-270

• Compatibility: CPU
• Features: This Copper Shims thermal conductivity up to 401w / mk, and ordinary copper thermal conductivity is only 20-30w / mk CPU and GPU graphics card in the inside part of the laptop using a thermal plastic thermal conductivity, thermal plastic at high temperature for a long time easy to aging, and ultimately lost, leading to overheating of the CPU or GPU, the Laptop will not start after overheating. With this copper pad to greatly lower gpu temperatures, can be used for graphics, northbridge, CPU chips. It can be used as heatsink solution for Xbox ,PS4 and all laptop and computer such as HP,Dell,Acer,Thinkpad etc. Package included: 10 pcs Thermal Conductive Copper Shims 20mm x 20mm x 0.8mm
• Dimensions: 20mm x 20mm x 0.8mm
• Model #: 11-001-271

• Model #: 11-001-289

• Model #: 11-001-325

• Color: Black
• Compatibility: Motherboard Chipsets
• Features: Product Description Aluminum IC heatsink for PC Chipset power transistor, FET, IC, power amplifier, Voltage Regulator,Computer VGA Northbridge Southbridge etc. Use heatsink adhesive glue to install heatsink on the IC.Glue is not included here. Please check the specification table and make sure that the size of the heatsink fits that of your component. Specification Product Name: Heatsink Material: Aluminium Color: Anodized Black Overall Size: 35mm x 35mm x 10mm Weight: 25g Package Content: 2pcs x Heatsink
• Dimensions: 35mm x 35mm x 10mm
• Model #: 11-001-261

• Color: Black
• Compatibility: Motherboard Chipsets
• Features: Product Description Aluminum IC heatsink for PC Chipset,graphics card, vidoe card,motherboard, power transistor, FET, IC, power amplifier, Voltage Regulator,etc. Use heatsink adhesive glue to install heatsink on the IC.Glue is not included here. Size is 19mm x 19mm x 5mm low profile Please check the specification table and make sure that the size of the heatsink fits that of your component. Specification Product Name: Heatsink Material: Aluminium Color: Anodized Black Overall Size: 19mm x 19mm x 5mm Weight: 25g Package Content: 10pcs x Heatsink
• Dimensions: 19mm x 19mm x 5mm
• Model #: 11-001-323

• Model #: 11-001-129

• Model #: 11-001-062

• Color: Silver
• Compatibility: Motherboard Chipsets
• Features: Product Description Aluminum IC heatsink for power transistor, FET, IC, power amplifier, Voltage Regulator, MOSFET, SCR, etc Use heatsink adhesive glue to install heatsink on the IC.Glue is not included here. Size is 20x20x6mm,Please check your component dimension carefully,and make sure size of the heatsink fits it no problem. Specification Product Name: Heatsink Material: Aluminium Color: Silver Tone Overall Size: 20mm x 20mm x 6mm Weight: 35g Package Content: 10pcs x Heatsink
• Dimensions: 20mm x 20mm x 6mm
• Model #: 11-001-258

• Model #: 11-001-330