2PCS 2.13inch E-Ink Display HAT, 250x122 Pixel E-Paper, SPI Interface | for Raspberry Pi 5/4B/3B+/3B/2B/Zero W/WH/Zero 2 W/Jetson Nano, Black/White Two-Color, Support Partial Refresh, V4 Version

Overview

This is 2.13inch E-Ink display HAT V4 for Raspberry Pi series boards, Jetson Nano. 2.13inch 250x122 resolution black and white Two Display colors, with embedded controller, communicating via SPI interface, supports partial refresh.

Due to the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.

Features

Standard Pi 40PIN GPIO extension header, compatible with Raspberry Pi series boards (includes Raspberry Pi 5/4B/3B+/3B/2B/Zero W/WH/Zero 2 W,etc. ) and compatible with Jetson Nano.

No backlight, keeps displaying last content for a long time even when power down

Ultra low power consumption, basically power is only required for refreshing

SPI interface, for connecting with controller boards like Arduino/STM32, etc.

Onboard voltage translator, compatible with 3.3V / 5V MCUs

Comes with Online Development Resources and Manual: bit.ly/3hZh77i

Specifications

Operating Voltage: 3.3V/5V

Resolution: 250 × 122 pixels

Interface: 3-wire SPI, 4-wire SPI

Display Color: black, white

Grey Scale: 2

Partial Refresh Time: 0.3s

Full Refresh Time: 2s

Refresh Power: 26.4mW(typ.)

Standby Power: <0.017mW

Viewing Angle: >170°

Dot Pitch: 0.194 x 0.194

Display Size: 48.55 × 23.71mm

Outline Dimension: 65mm x 30.2mm

Onboard SPI control interface

SYMBOL--DESCRIPTION

VCC-- 3.3V/5V

GND--Ground

NC--NC

DIN--SPI MOSI pin

CLK--SPI SCK pin

CS--SPI chip selection, low active

DC--Data/Command selection (high for data, low for command)

RST--External reset, low active

BUSY--Busy status output, high active

PACKAGE CONTENT

2.13inch e-Paper HAT x2

RPi screws pack (2pcs) x2

PH2.0 20cm x2