JVFYI M.2 Key M SATA3.0 Expansion Card

Compliant with M.2 Key M standard

Transfer protocol: PCIe x2

Supports up to two lane of PCI Express

Complies with PCI Express Base Specification Revision 3.1a

Supports PCIe Link layer power saving mode

Support NVMe M.2 Key M SSD including 2280 drives

Supports 5-SATA Port

Each SATA Port transmit speeds up to 6Gbps

Support command-based and FIS-based of Port Multiplier

Complies with SATA Specification Revision 3.2

Supports AHCI mode and IDE programming interface

Supports Native Command Queue(NCQ)

Supports SATA Link Power saving mode(partial and slumber)

Supports SATA plug-in detection capable

Supports drive power control and staggered spin-up

Supports SATA Partial/Slumber power management state

Plug-and-Play Supported, no additional software installation or settings required

Chipset: JMB585

Drivers support for Linux , Win7/ Win8/Win8.1 /win10, 32 or 64bit

Package content

1 x M.2 Key M SATA3.0 Expansion card

1 x Users Manual

5 x SATA Cable

System Requirements

Linux base OS, Win7/ Win8/Win8.1 /win10, 32 or 64bit

Available M.2 Key M slot

Hardware Description:

Hardware installation

1.Turn off the power to your computer

2.Unplug the power cord and remove your computers cover

3.Locate to an empty M.2 slot on the motherboard, Move the board against the housing chamber, see figure 1

4.To install the board, Rotate module to 25. Insert it until the board surface reaches the ramp figure2,3

5.Rotate the board to horizontal position, see figure 4.

6.Fix the board by screw, see figure5

7.Attach your internal device to the SATAIII controller card

8.Replace the computer cover and reconnect the power cord

Install Drivers and software

Windows Operating Systems

For Windows 7,8,8.1,10 System Operating.

No need other driver, Using Windows In-box drivers to install the JMB585 adapter.