Net Sleeved 12 inch IDE Molex to 3 x TX4 4-pins PWM CPU Case Cooling Fan Splitter Hub Power Adapter Cable w/ RPM Feedback

Features

Power from PSU Molex 4-pin LP4,supporting three PWM fans from a single motherboard header

Since only one RPM signal can be read by one motherboard connector, only one   4 TIPS CONNECTOR of the fan splitter cable carries an RPM signal; thus the motherboard will only read the RPM signal of the PWM device that is connected to full 4-pin connector. 

The other two male connectors are missing the pins of tachometric signal,ensure your fan speed monitor won't bounce all over the place from getting three sense signals.Guarantee motherboard getting an accurate RPM signal. 

Only one of the three fans sends its tach signal (the one with full 4-pin connector) reports its RPM, but the others will still follow the PWM signal.

TX4 4-pin female connect to motherboard for RPM feedback,allowing all fan speed to be synchronized with CPU load 

Compatible with 4pin PMW fan connector and 3pin fan connector  (Due 3pins no PWM controller, 3pin fans would run in full speed.)

Power from PSU 12V DC only,do not utilize for 5V DC fan

Sleeved in a is enhanced cable management,enclosure to provide a sleeker look that seamlessly integrates into the case's interior

Specifications

Color : sleeved cable

Wire Gauge: 26AWG Tinned Copper - UL1007 Wire

Cable Length: 12 inch

Connector A: 1 - 5.25" Molex 4 pin LP4 Male

Connector B: 1 - TX4 4-pin Female for RPM feedback -Connect to motherboard

1- TX4 4-pin Male

2 - TX4 4-pin Male (3 wires only,missing the pin of tach)

Voltage:12V DC

Note:

Only the fan on 'CPU Fan' channel is used for monitoring. 

This is only a fan splitter cable,NOT fan speed controller,