HT30A+301 Hantek Oscilloscope Accessory Set HT301 Breakout Leads with HT30A Auto Test Leads Set for Measurement (HT30A+301)

HT30A: A special line for assisting automobile measurement instruments to test various types of signals. It consists of wide range probes, clips, gators can be plugged into the 4 mm connectors at the end of the cable
HT30A: 3M BNC to banana adapter cable, heavy duty auto test lead. Allowing the oscilloscope away form the car being tested or repaired and placed on the bench
HT30A: To avoid the lines twisting together, the 2 connectors has different length. The short line is earth wire, and the long line is positive pole which should be connected with the auto engine cable
HT301: This breakout lead is easy to take voltage readings from numerous sensors in vehicle engine compartment
HT301: Connect the breakout lead plugs into the existing wire loom, and insert the two 4mm banana plugs into the oscilloscope using test lead HT30A, the output signal can be taken
HT301: Work with multi-point injection nozzle, single-point injection nozzle, induction crankshaft sensor or camshaft sensor, temperature sensor, knock sensor, GM ignition coil and so on