Yassdwbn Radio Add Amp Subwoofer Amplifier Wire Harness For Chevy 2010-2017 For Chevrolet

Radio Add Amp Subwoofer Amplifier Wire Harness For Chevy 2010-2017


Remove your factory radio
Unplug the factory wiring and plug in this wire harness
Reinstall your factory radio

What is it?

This wire harness provides a connection for one set of cables to provide an audio signal to an external amplifier, as well as an add-a-circuit with remote wire for the remote amplifier turn on wire. This wire, along with a set of cables, is run to your aftermarket amplifier. All thats left for you to do is connect the main power wire from your battery and ground. (Not included)


Compatibility Notes
Audio volume to the amplifier can be adjusted by the dials on the harness. For easier access we recommend using an external volume knob.(Not included)
The radio circuit is most common however any that turns on/off with the ignition could be used if deemed appropriate.
A variety of wire colors may be used for the remote wire coming off the harness. Regardless of color, rest assured it is for the remote turn on of an amplifier.

Part Number: 71-2106


Compatible with these models:
For Buick Regal 2011-2013
For Buick Regal 2011-2012
For Buick Regal 2011-2012
For Buick Regal 2011-2012
For Buick Regal 2011-2012
For Chevrolet Camaro 2010-2015
For Chevrolet Cruze 2011-2015
For Chevrolet Cruze 2011-2015
For Chevrolet Cruze Limited 2016
For Chevrolet Cruze Limited 2016
For Chevrolet Equinox 2013-2017
For Chevrolet Equinox 2010-2015
For Chevrolet Express 2013-2015
For Chevrolet Malibu 2013-2015
For Chevrolet Malibu 2013-2015
For Chevrolet Malibu Limited 2016-
For Chevrolet Malibu Limited 2016
For Chevrolet Sonic 2012-2016
For Chevrolet Spark 2013-2015
For Chevrolet Trax 2015-2016

Package Include: 1 Set Wire Harness(As picture show)

Converter adjustment instructions:
After completing all of the necessary connections, turn the adjustment pots all of the way down by rotating them completely counter-clockwise.
Turn the stereo system on and adjust the main volume control on the stereo to approximately 3/4 maximum volume.
Select one of the adjustment pots and turn it slowly clockwise until you notice audio distortion and then stop.
Turn the remaining pot to the same position as the previously adjusted pot.