Unleash the power of Platinum! OCZ's Platinum Edition dual channel 4GB kit is rated to run at 1066MHz and has CL 5-5-5-18 timings for speedy performance. Each kit is 100% hand tested for performance and compatibility.
The XTC heat spreaders are designed to take advantage of the micro convection currents that occur in the channels between the individual memory chips. The platinum mirrored honeycomb design encourages maximum heat distribution. The rigid frame, in addition to proclaiming to the world what memory you use also helps to reinforce structural rigidity in the module.
This 4GB kit ensures optimal performance via an ideal combination of low voltage requirements, speed, and latency, so it's a great match for the Nehalem platform to unleash performance you could only dream of before.
-
- 5
-
- 66%
- 4
-
- 12%
- 3
-
- 8%
- 2
-
- 6%
- 1
-
- 8%
| Product Rating: |
 
|
| Total Reviews: |
756 |
how to guide
- Pros: after setting all timings, voltage, and memory bus frequency you can to achieve their manufactured speeds.
- Cons: TCL: 5
TRCD: 5
TRP:5
TRAS: 15
CMD: T2
TRRD: 3
TRC: 24
TWR: 5
TWTR: 9
TREF: 7.8us
now set your memory bus speed to 1066 mhz, and set volt from 1.9 to 2.2. but do not go over 2.2 or you will void your worrenty.
- Other Thoughts: i just happend to notice one day my ram was running at half the speed it was suppose to so i went to thare forums spent all day digging and trouble shooting and finally came to this, these settings work for most but not all. so i hope newegg allows me to post this so not every one has to spend all day trying to achieve the speeds they bought but did not get.
Nice Ram...
- Pros: Heat spreader, price, it runs at stated 1066 if you change the timings correctly. Does not run hot!!!
- Cons: None so far.....
- Other Thoughts: I see many peeps complaining about their bios showing 800MHz as far as speed goes. If you were one of these peeps then that means you are a noob and you should have done your research prior to purchasing. The reason it shows 800MHz in bios is due to the fact that OCZ has to make sure these modules are compatible with MOST motherboards, meaning all you have to do is go into the bios and change the freq. and timings to have them run at 1066MHz. Example : Go into bios, under the ram freq. change it from 800 to 1066MHz, then change the timings to 5-5-5-15 and the up the voltage to 2.1v and vualaaa you are running at 1066MHz.
I didnt mean to offend anyone but most of the negative reviews are written by peeps that dont know what they are doing in the first place. And I dont think that you are entitled to give a bad review if you didnt know what you were doing at the time of installing the ram.
| Model | OCZ2P10664GK |
| Type | 240-Pin DDR2 SDRAM |
| Capacity | 4GB (2 x 2GB) |
| Speed | DDR2 1066 (PC2 8500) |
| Cas Latency | 5 |
Reviewed By: Krash on 12/22/2008
Tech Level: somewhat high - Ownership: 1 month to 1 year
