Stepper Motor HAT for Raspberry Pi 4B/3B+/2B/B+/Zero/W/WH/and Jetson Nano,DRV8825 Motor Controller Drives Two Stepper Motors, Up to 1/32 Microstepping,Use for 3D Printer,Sculpturing Machine etc

This Stepper Motor HAT gives your Raspberry Pi the ability to drives two stepper motors at the same time, supports up to 1/32 microstepping.

Features
Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano. Onboard dual DRV8825 motor controller IC with built-in microstepping indexer, drives two stepper motors, easy to use, 6 available microstepping modes, configured with the
DIP switches: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step
Adjustable motor drive current via potentiometer, maximum 2.5A current output.
Protection features: Overcurrent Protection (OCP), Thermal Shutdown (TSD), VM Undervoltage Lockout (UVLO), Integrates 5V regulator, allows providing power to Raspberry Pi
Onboard multi connector options for stepper motors in different specifications, Comes with development resources and manual (examples in BCM2835, wiringPi, and python)

Specifications

Motor controller: DRV8825
Motor drive voltage: 8.2V ~28V
Motor drive current: 2.5A
Logic voltage: 3.3V
Dimension: 65mm x 56mm
Mounting hole size: 3.0 mm
Applications
3D Printer
Sculpturing machine
Mechanical arm

PACKAGE CONTENT
Stepper Motor HAT x1
RPi screws pack (2pcs) x1

Note: Raspberry Pi and stepper motors in the photos are NOT included.