NGW-1pc CANBed DUAL - RP2040 chip based Arduino CAN Bus dev board with 2 independent CAN Bus interfaces(CAN2.0 & CAN FD)

CANBed DUAL, a CAN Bus development board, is based on the RP2040 chip which is the debut microcontroller from Raspberry Pi. It brings signature values of high performance, low cost, and ease of use to the microcontroller space. There are 264 KB of SRAM and 2MB of Flash memory on board. The operating frequency is up to 133MHz, and it contains a 6PIN Terminal and a flexible Micro USB connector where you can either program the board or supply power to the board. The voltage input range is 9-28V which provides a stable 5V/1A output.

There are also rich interfaces on board including one I2C, one UART, one SPI interface, three analog input interfaces, and eight digital IO

CANBed DUAL has two independent CAN Bus interfaces which are CAN 2.0 and CAN FD, and it uses high-performance GD32E103CBT6 as the CAN controller. With CANBed Dual, you can learn CAN Bus communication, build product prototypes and read the data from the car. Also, as a part of your product, it integrates the processes of designing the MCU and the CAN Bus, and you only need to complete other hardware designs.
Applications
Learn CAN Bus communication

Read the data from the car

Build product prototypes

Specification
Parameter

Details

MCU

RP2040

Processor

Dual ARM Cortex-M0+

Clock Speed

flexible clock running up to 133MHz

Flash Memory

2MB

RAM

264KB

Operate Voltage

9-28V

Output Current @ 3.3V

1A

Input Interface

sub-D

Partlist
CANBed Dual PCBA

1

6 Pin Terminal connector

1

6 Pin Switch

2

9x2 2.54 Header

1

3x2 2.54 Header

1