Are you an E-Blast Insider?
G1/2 Water Solenoid Valve DC 12V N/C Normal Closed 19mm Male Thread Outlet Valves
- This is an Outlet Water Solenoid Valve for hot Liquid not more than 117℃, turn on water when system start and cut off water when system stop.
Operation Mode: N/C
Thread Diameter: G1/2"
Thread Length: 19mm/0.75"
Screw Hole Dia: 2.3mm/0.09"
Screw Hole Distance: 25mm x 25mm (L*W)
Total Size: 84mm x 36mm x 55mm (L*W*H)
Liquid Temperature: Less Than 100?
Working Temperature: Less Than 50?
Flow Direction: Unidirectional (Follow the Arrow on Valve Body)
Media: Purified Water, Water, Not suitable for acid and alkali, thick, viscous liquids and all other non-liquids
Install and Use Attentions:
1. The water solenoid valve selects the corresponding voltage and temperature according to the actual situation when selecting type.
2. When install the solenoid valve, medium flow direction must be consistent with the direction arrow as shown in the valve body, the valve must be installed in horizontal pipe runs. Solenoid valve coil keep in a vertical position, the valve can not be put in places with splashing water or water leakage.
3. Please install a filter screen at the inlet end to avoid inhalation of impurities so that the solenoid valve can not be reset, resulting in water closes or obstructed opening.
4. If the solenoid valve is closed or blocked, please open the top four screws to clean the inner cavity impurities.
5. During use solenoid valve should be regularly cleaning dirt on the surface of the movable iron core and the piston, sealing gasket should be checked at the same time in dismounting, damaged should be replaced timely when found.
6. Before installing the solenoid valve, pipeline should be cleaned.
1 x Solenoid Valve
Warranty & Returns
Warranty, Returns, And Additional Information
- Return for refund within: 30 days
- Return for replacement within: 90 days
- This item is covered by Unique Bargains Return Policy