K-300 50ml Transparent UV Glue UV Curing Adhesive Crystal and Glass Adhesive with 51 LED /9 LED UV Flashlight

Specification:Appearance: colorless or light yellow transparent liquid

Capacity: 50ml

Viscosity cps(25 C): <110

Curing time(25 C): Depend on UV intensity

Hardness ( Shore D): =75

Tensile shear strength: = 10MPa

Bottle size: (H*W)about 15.5cm*5.5cm

Shelf life: 12 months

Feature:Low odor, high transparency.

High bonding strength, low viscosity and easy deaeration.

Easy to use.

220-260nm light source helps surface cure.

Used in large area glass crystal bonding.

For glass mosaic, glass crafts, crystal crafts and other products bonding.

Use Steps:1. Depending on the material surface treatment, surface dry and clean, no weak boundary layer.

2. Interface adhesive bonding material on the need for continuous coating, be careful not to disperse.

3. Light positioning the glue into the short ultraviolet curing lamp radiation, until the hand nudging fixed.

4. Full cure time high radiation, until fully cured, note the temperature is not too high.

5. Dipped in acetone, alcohol, cleaning materials with a soft cloth or paper towel and gently wipe the bonding good material.

Note:The UV lamp positioned curing, the curing rate is dependent on the glue to absorb light energy from the light source associated with, the light transmittance material and other factors.

The operation should not squeeze too hard to be sticky, and shall not be repeatedly moved apart adherend.

You can wipe with acetone, hair dryer.

Using the rest of the glue not fall back to the original packaging to avoid contamination.

Avoid contact with eyes, skin and clothing. If accidentally splashed into the eyes, rinse immediately with plenty of water.